McCulloch M195-42T Manuale Proprietario

• 

Remove bolt and flat washer se cur ing seat to cardboard 

packing and set aside for as sem bly of seat to tractor.  

Remove the cardboard packing and discard.

•  Connect switch to seat.
•  Place seat on seat pan so all three (3) bottom pads 

are positioned over large slotted holes in pan.

•  Push down on seat to engage pads in slots and pull 

seat towards rear of tractor.

•  Raise seat and tighten bolt securely.
•  Remove tape and discard.
•  Lower seat into operating position and sit on seat. 

Press clutch/brake pedal all the way down. If operating 

position is not comfortable, adjust seat.

•  Grasp adjustment handle and pull up, slide seat to 

desired po si tion and release adjustment handle.

The tires on your tractor were overinflated at the factory 

for shipping purposes.  Correct tire pressure is important 

for best cutting performance.
•  Reduce tire pressure to PSI shown on tires.

For best cutting results, mower housing should be prop-

erly leveled.  See “TO LEVEL MOWER HOUSING” in the 

Service and Adjustments section of this manual.

See the figures that are shown for replacing motion and 

mower blade drive belts in the Service and Adjustments 

sec tion of this manual.  Verify that the belts are routed 

cor rect ly.

After you learn how to operate your tractor, check to see that 

the brake is operating properly.  See “TO CHECK BRAKE” 

in the Service and Adjustments section of this manual.

NOTE: You may now roll your tractor off the skid. Follow 

the instructions below to remove the tractor from the skid.

  WARNING: Before start ing, read, un der stand and fol-

 low all in struc tions in the Op er a tion section of this man u al. 

Ensure tractor is in a well-ventilated area. Ensure the area 

in front of tractor is clear of other peo ple and objects.

•  Raise attachment lift lever to its highest po si tion.
•  Release parking brake by de press ing clutch/brake 

ped al.

•  Place freewheel control in "TRANS MIS SION DIS EN-

 GAGED" position.  (See “TO TRANS PORT” in the 

Op er a tion section of this manual.)

•  Roll tractor forward off skid.
• 

Remove banding holding the deflector shield up against 

tractor.

Continue with the instructions that follow.