LXE MX5X Manuale Utente

Appendix C  MX5X CE .NET 4.2 

269 

E-EQ-MX5CERG-F-ARC 

MX5X Reference Guide 

With a Cisco wireless device installed, open the Wireless network properties as described in 
Wireless Network Configuration, later in this section. With the Authentication tab selected check 
the text in the EAP type drop down box. Refer to the following figures to determine if Cisco 
PEAP is installed. 

 

 

Cisco PEAP Installed 

PEAP Installed 

If the Cisco installation is correct, continue with the configuration. If it is not correct, follow the 
procedures below. 

There are two Cisco CAB files in the \SYSTEM folder of the MX5X. The default files are 
CISCO.CAB and CISCOPEAP.CAB. 

The default CISCO.CAB file provides for all authentications except Cisco PEAP. When the 
default CISCO.CAB file is loaded, the Wireless Network Properties screen looks like the previous 
figure labeled PEAP Installed. 

If Cisco PEAP is desired: 

1.  Rename the CISCO.CAB file to CISCOMSCHAP.CAB. 

2.  Rename the CISCOPEAP.CAB file to CISCO.CAB. 

3.  Coldboot the mobile device to install the new driver with the registry. 

The renamed CISCO.CAB file provides for Cisco PEAP and PEAP/GTC authentications. When 
the renamed CISCO.CAB file is loaded, the Wireless Network Properties screen looks like the 
previous figure labeled Cisco PEAP Installed. 

If it becomes necessary to switch to a different authentication than Cisco PEAP or PEAP/GTC, 

1.  Rename the CISCO.CAB file to CISCOPEAP.CAB. 

2.  Rename the CISCOMSCHAP.CAB file to CISCO.CAB 

3.  Coldboot the mobile device to install the new driver with the registry.