LUCE PT-L6510E Manuale Utente
24
Leveling the Projector
For the best viewing result free from distortion, the
projector should be carefully leveled on its base.
Follow the steps below to correct the tilt angle of the
projector when it is installed on a floor-standing base.
projector should be carefully leveled on its base.
Follow the steps below to correct the tilt angle of the
projector when it is installed on a floor-standing base.
Adjusting the Vertical Position of
the Picture
The vertical position of the picture can be adjusted
using the electric “LENS SHIFT” buttons on the rear
control panel. Do this adjustment after the projection
distance and projector position have been
determined.
using the electric “LENS SHIFT” buttons on the rear
control panel. Do this adjustment after the projection
distance and projector position have been
determined.
• Adjusting vertical position with the “LENS
SHIFT” buttons:
2. Release the LEVELING levers.
The leveling feet lock in place.
3. Make fine leveling adjustments by
manually turning the leveling feet.
<Retracting the Leveling Feet>
While lifting the front side of the projector, raise the
Leveling lever, and then slowly lower the unit.
Caution
• Keep holding the projector until both leveling
feet touch the base surface.
Note
• The maximum length of the leveling foot is 47
mm. If it is rotated on reaching that length it will
turn freely without extending further.
• If the picture has keystone distortion, do
keystone adjustment from the menu. (page 32)
Caution
• Do not press the LEVELING levers without
holding the projector with your hands.
Otherwise, the leveling feet will be unlocked and
the projector may drop rapidly onto the projector
base surface, possibly leading to damage.
• Adjusting vertical position from the menu:
Alternatively, you can adjust the vertical position of
the picture by choosing the “LENS SHIFT” option
from the “OPTION 1” menu chosen from the MAIN
MENU (see page 34).
the picture by choosing the “LENS SHIFT” option
from the “OPTION 1” menu chosen from the MAIN
MENU (see page 34).
LEVELING Lever
on each side.
on each side.
LEVELING feet
47 mm
Press the button to shift
the picture upward.
Press the button to shift
the picture downward.
REMOTE
RGB OUT
OUT
WIRED
WIRED
IN
IN
OUT
IN
R/R-Y/PR
G/Y
SYNC/HD
VD
B/B-Y/PB
IN
OUT
OUT
IN
R
L
USB
SERIAL
S-VIDEO IN
AUDIO IN
RGB
AUDIO AUDIO
VIDEO
RGB 2 IN
OUT
IN
DVI-D
RGB 1 IN
> PC <
TBMU152
OUT
Starting to use
1. While lifting and holding the front side of
the projector to the level position, pull and
hold the LEVELING button on each side
of the bottom panel until the leveling feet
rest on the projector base surface.
hold the LEVELING button on each side
of the bottom panel until the leveling feet
rest on the projector base surface.
Caution
When shifting the lens, be careful not to
catch your fingers between the lens and
shroud.
catch your fingers between the lens and
shroud.