LUCE PT-L6510E Manuale Utente

8

The projection lens is extremely susceptible to vibration

and shocks. When carrying the projector, be careful not to

subject to excessive vibration or shock while under

transport.

Observe the following at all times when setting up the

projector.

If the projector is set up in locations with strong vibration,

such as near a motor, or if it is installed inside a vehicle or

on board a ship, the projector may be subjected to vibration

or shocks which can damage the internal parts and cause

malfunctions or accidents. Accordingly, set up the projector

in a place which is free from such vibrations and shocks.

The projector may be subject to electromagnetic

interference if it is set up near high-voltage power lines or

motors.

If the projector is to be suspended from the ceiling, you

will need to purchase the separate installation kit (Model

No.: ET-PKL6500/S). Furthermore, all installation work

should only be carried out by a qualified technician.

This product cannot be used at altitudes of 1,400 m or

more above sea level. If it is used as is, there may be an

adverse effect on component service life and so on.

If outside light or light from indoor lamps is shining onto

the screen, the images projected will not have good

contrast. Draw curtains or blinds over any windows and

turn off any fluorescent lights near the screen to prevent

reflection.

Depending on the environment where used, hot air from

the cooling fan vent may in rare cases cause disturbances

on the screen.

If the surface of the lens becomes dirty from fingerprints

or anything else, this will be magnified and projected onto

If the cabinet is particularly dirty, soak the cloth in water

with a small amount of neutral detergent in it, squeeze

the cloth very well, and then wipe the cabinet. After

cleaning, wipe the cabinet dry with a dry cloth.

Do not wipe the lens with a cloth that is dusty or which

produces lint.

If any dust or lint gets onto the lens, such dust or lint

will be magnified and projected onto the screen. Use

a blower to clean any dust and lint from the lens

surface, or use a soft cloth to wipe off any dust or lint.

the screen. Moreover, when not using the projector, cover

it with the accessory lens cover.

If the screen you are using is dirty, damaged or discolored,

attractive projections cannot be obtained. Do not apply

any volatile substances to the screen, and do not let it

become dirty or damaged.

A mercury lamp with high internal pressure is used as the

light source for this equipment. High-pressure mercury

lamps have the following characteristics.

• If the lamp deteriorates due to shock, scratching or the

passage of time during use, it may rupture with a loud

noise, or enter the unlit state and end its service life.

 • Service life varies significantly due to individual lamp

differences and use conditions.

 • Exceeding the replacement period will increase the

probability of rupture.

The liquid crystal panel of the projector is built with very

high precision technology giving you fine picture details.

Occasionally, a few non-active pixels may appear on the

screen as a fixed point of blue, green or red.

Please note that this dose not affect the performance of

your LCD.

If the projector is subjected to a continuous use for more

than 6 hours every day, you may have to replace optical

parts, such as LCD panels or polarizers within less than

one year. When you use the projector in such a case, ask

your dealer or an Authorized Service Center for details.