Liebert Universal Monitor Manuale Utente

To use the modem and pager features, be sure to connect the phone line connector to a telephone wall 

jack using an RJ11 cord, as described in 4.6.2 - Phone Line Connector.

The Universal Monitor has an on-board modem that offers dial-up access to all LCD functions as well 

as features available only through the Service Terminal Interface (see A.1 - Comparison of Func-

tions: LCD and Service Terminal Interface). The modem also permits remote notification of 

alarms. 

Supported settings vary for different types of access:

Table 27 shows the default settings for modem options.

To configure the modem:

Log In and Choose Setup System
1. From the Main Menu, use the arrows

↑ ↓

 to

 

choose System and 

Control, then press Enter ↵  (see 9.1 - Login for help).

2. Enter your password at the Login screen.
3. From the System and Control Menu, use the arrows

↑ ↓

 to

 

choose 

Setup System, then press Enter ↵ .

9600 baud, no parity, 8 data bits, 1 stop bit

9600 baud, even parity, 7 data bits, 1 stop bit and TAPI protocol version 1.8

For calls involving countries that do not support country code B5 (see Table 28):
• Modem model MT5600SMI is required (model number is on the modem label).
• +GCI=xx (xx is the country code) must be added to the initialization string (see Step 7 in 

this section).

Initialization String (Init String)

Any string (up to 40 characters); for international dialing, 

add +GCI=xx, where xx is the country code (except B5 

countries—see Table 28)

Enable Modem Diagnostic Messages

N (disable)

Y (enable)

Modem Dial Prefix

Any string

Modem Hang Up Delay After a Call

10 seconds

Any number (up to 99 seconds)

SETUP INPUT
SETUP COMMON ALARM
SETUP SENSOR
SETUP I/O MATRIX

↑ ↓=NEXT

↵

=SELECT

SETUP OUTPUT

SETUP SYSTEM INFO
SETUP EXP BOARD