Legacy Car Audio LCDCS94 Manuale Utente
TROUBLE SHOOTING
Before going through the check list, finish wiring connection. If there still are
any question after finish testing the items in the following list, consult your
nearest service dealer.
any question after finish testing the items in the following list, consult your
nearest service dealer.
Symptom
Cause
The fuse is blown.
Replace the fuse with another 15A
fuse.
fuse.
Switch the ignition to the "ON" or
"ACC" position.
"ACC" position.
No power.
Select a station using manual tuning.
The signals are weak.
The radio does
not stop on any
stations when
automatic
tuning is used.
not stop on any
stations when
automatic
tuning is used.
Insert the antenna cable firmly into
the antenna jack on the unit.
the antenna jack on the unit.
The antenna cable is not
connected.
connected.
No radio
reception.
reception.
Turn the power off and then on
again.
again.
Eject the disc or tape, then insert it
again.
again.
The microcomputer has been
affected by electrical noise.
affected by electrical noise.
The unit does
not work
properly (Eject,
Load, Play).
not work
properly (Eject,
Load, Play).
The vehicle ignition is switched
off.
off.
Clean the disc.
The disc is dirty.
Try another disc. If it plays properly,
the first disc may be defective.
the first disc may be defective.
The disc is defective.
Install the unit securely. Be sure to
use the rear strap if the vehicle
does not provide support for the
rear of the unit.
use the rear strap if the vehicle
does not provide support for the
rear of the unit.
The unit is not mounted
securely.
securely.
Wait for the road surface to
improve before playing a disc.
improve before playing a disc.
The road surface is rough.
The sound from
the CD player
skips.
the CD player
skips.
Check the +12V and ground
connections.
connections.
The power connections are not
wired correctly.
wired correctly.
The volume control is turned
down.
down.
The compact
disc or tape
does not play
when inserted
into the unit.
disc or tape
does not play
when inserted
into the unit.
Solution
Turn up the volume control.
10-11-12-16-17-18. 1-6 PRESET MEMORY BUTTONS
Select the desired band, then tune for the station you want to store in
memory, and then press and hold one of 1-6 preset memory buttons
for more than 2 seconds to store the broadcasting station to the preset
memory. Every preset memory button can be stored only one station for
each band, so the car audio system can be stored 30 stations.
After finishing the storing operation, select the desired band and then
press one or the six preset memory buttons to quickly tune for the
desired station.
Select the desired band, then tune for the station you want to store in
memory, and then press and hold one of 1-6 preset memory buttons
for more than 2 seconds to store the broadcasting station to the preset
memory. Every preset memory button can be stored only one station for
each band, so the car audio system can be stored 30 stations.
After finishing the storing operation, select the desired band and then
press one or the six preset memory buttons to quickly tune for the
desired station.
10. AMS BUTTON(Automatic Music Select System)
In tape mode, press AMS button to turn on the AUTOMATIC MUSIC SELECT
SYSTEM. Then if you press FF or REW button, it allows you to skip forward
or backward to the beginning of a particular selection.
Press AMS button again to cancel AMS mode.
In tape mode, press AMS button to turn on the AUTOMATIC MUSIC SELECT
SYSTEM. Then if you press FF or REW button, it allows you to skip forward
or backward to the beginning of a particular selection.
Press AMS button again to cancel AMS mode.
11-12. DISC SELECTING BUTTONS
In CD changer mode, press the DISC + button to select the next disc and
the DISC - button to
the DISC - button to
select the preceding disc.
9. TUNE/SEEK/TRACK UP OR DOWN, FF/RW BUTTONS
In radio mode, press UP or DN button, it will start automatic tuning and
stop at the next receivable station; press UP or DN button for more than
2 seconds to research for the higher or lower frequency station.
In tape mode, press UP or DN button to fast forward or rewind the tape,
and press TAPE button to resume normal tape playing.
In CD player or CD changer mode, press UP or DN button to skip to the
beginning of the next track or one of the track currently playing. Press
DN button twice to skip to the beginning of the previous track. Press and
hold UP or DN button for more than 2 seconds to search quickly (with
sound) in the forward or reverse direction, and press it again to resume
normal playing.
stop at the next receivable station; press UP or DN button for more than
2 seconds to research for the higher or lower frequency station.
In tape mode, press UP or DN button to fast forward or rewind the tape,
and press TAPE button to resume normal tape playing.
In CD player or CD changer mode, press UP or DN button to skip to the
beginning of the next track or one of the track currently playing. Press
DN button twice to skip to the beginning of the previous track. Press and
hold UP or DN button for more than 2 seconds to search quickly (with
sound) in the forward or reverse direction, and press it again to resume
normal playing.