Legacy Car Audio LCD97DFX Manuale Utente
Page. 4
P / N : 570-991612-06
WIRE CONNECTION
RESET FUNCTION
UNIT REMOVAL
1. Remove Front Control Panel.
2. Slightly insert the key into the slot and
2. Slightly insert the key into the slot and
gently to release.
3. Separate the sleeve from the unit. Keep
release key in a safe place as you may
need for future removal of unit.
need for future removal of unit.
INSTALLATION
REMOTE CONTROL
P / N : 570-991612-06
The RESET button is located at the back of the
panel. It is recessed in order to prevent accidental
engagement, and can be activated with the tip of a
ball-point pen or any similar pointed object. This
reset circuitry is provided in order to protect the
unit's microprocessor, and should only be activated
under the following conditions :
a) Initial installation after all wiring is completed.
b) Abnormal operation is encountered such as
numerical indication on display is erratic.
c) Whenever the reset button is activated, all preset
memory content will be erased and must be
reprogrammed.
panel. It is recessed in order to prevent accidental
engagement, and can be activated with the tip of a
ball-point pen or any similar pointed object. This
reset circuitry is provided in order to protect the
unit's microprocessor, and should only be activated
under the following conditions :
a) Initial installation after all wiring is completed.
b) Abnormal operation is encountered such as
numerical indication on display is erratic.
c) Whenever the reset button is activated, all preset
memory content will be erased and must be
reprogrammed.
CAUTION : Do not connect the speaker wires to
chassis or car body. Each speaker wire cannot be
soldered together with other wires. Otherwise, the unit
will be damaged and no sound will come out anymore.
chassis or car body. Each speaker wire cannot be
soldered together with other wires. Otherwise, the unit
will be damaged and no sound will come out anymore.
CAUTION : DO NOT PLACE THE UNIT OVER THE
M A X I M U M I N S TA L L AT I O N A N G L E O F 3 0 °.
O T H E RW I S E , T H E U N I T M AY N O T W O R K
PROPERLY.
M A X I M U M I N S TA L L AT I O N A N G L E O F 3 0 °.
O T H E RW I S E , T H E U N I T M AY N O T W O R K
PROPERLY.
WARNING!!
Due to protection of CD Mechanism, two small screws on the top
of the unit must be released before operate the unit. Otherwise, the
CD Mechanism can not be working properly.
of the unit must be released before operate the unit. Otherwise, the
CD Mechanism can not be working properly.