Laser beta lasermike LS8000-3 Manuale Utente
LaserSpeed 8000-3 Instruction Handbook
Introduction
Part No. 93463 / Drawing No. 0921-01561
Page 14 of 221
Revision A (Sep 2007)
Introduction
This manual describes the installation and setup of the LaserSpeed 8000
gauge. For daily routine usage, see the LaserSpeed 8000 Operator Guide.
gauge. For daily routine usage, see the LaserSpeed 8000 Operator Guide.
The Model LS8000-3 LaserSpeed® Non-contact Length and Speed gauge is
an industrial, Laser-Doppler based instrument that measures the velocity and
length of material. Due to the nature of the laser-based measurement, there is
no physical contact with the material. This eliminates the problems of wheel
wear and slippage that plague mechanical/encoder based length
measurement systems.
an industrial, Laser-Doppler based instrument that measures the velocity and
length of material. Due to the nature of the laser-based measurement, there is
no physical contact with the material. This eliminates the problems of wheel
wear and slippage that plague mechanical/encoder based length
measurement systems.
System Overview
The Model LS8000-3 is a stand-alone instrument that requires only 24 VDC
input power to operate. The system has a variety of industrial outputs. Also, a
variety of information including length, velocity, system operating parameters,
and setup parameters can be read and configured using the communications
interfaces.
input power to operate. The system has a variety of industrial outputs. Also, a
variety of information including length, velocity, system operating parameters,
and setup parameters can be read and configured using the communications
interfaces.
The LS8000-3 is permanently calibrated to a NIST traceable standard at the
factory. Aside from periodic cleaning of the optical window, the LS8000-3
does not require maintenance.
factory. Aside from periodic cleaning of the optical window, the LS8000-3
does not require maintenance.
See the
Specifications
section at the end of this manual.
Principle of Operation
LaserSpeed utilizes dual-beam interferometer technology to provide accurate
velocity readings. The measured velocity is integrated over time to measure
the length of moving objects. The opto-electronic portion of the LS8000-3
generates a laser beam that is split and then crossed in space. The two
crossing beams interact, producing a fringe pattern that is orthogonal to the
plane of the two beams.
velocity readings. The measured velocity is integrated over time to measure
the length of moving objects. The opto-electronic portion of the LS8000-3
generates a laser beam that is split and then crossed in space. The two
crossing beams interact, producing a fringe pattern that is orthogonal to the
plane of the two beams.
Light is scattered when material passes through the measurement region. This
scattered light is collected by the gauge and converted to electrical signals.
The frequency of the electrical signal contains information with regards to the
velocity of the material. The signal processor converts the electrical signals to
frequency information that is directly proportional to the velocity of the material
moving through the laser beams. The signal processor converts the frequency
information into velocity information and updates user outputs. In order to
determine if there is an object in the measurement area, the gauge measures
the amount of reflected laser light.
scattered light is collected by the gauge and converted to electrical signals.
The frequency of the electrical signal contains information with regards to the
velocity of the material. The signal processor converts the electrical signals to
frequency information that is directly proportional to the velocity of the material
moving through the laser beams. The signal processor converts the frequency
information into velocity information and updates user outputs. In order to
determine if there is an object in the measurement area, the gauge measures
the amount of reflected laser light.