Lanner electronic FW-7650 Manuale Utente

 

When you press “Enter” on this item, you get a confirmation dialog box with a message similar 
to: 
 
Load Optimized Defaults (Y/N) ? N

Pessing “Y” loads the default values that are factory settings for optimal performance 
system operations

 

Te “SUPERVISOR/USER PASSWORD” utility sets the password.  The SBC is shipped with 
the password disabled.  If you want to change the password, you must first enter the current 
password, then at the prompt -- enter your new password.  The password is case sensitive, and 
can be up to 8 alphanumeric characters.  Press <Enter> after you have finished typing in the 
password.  At the next prompt, confirm the new password by re-typing it and pressing <Enter> 
again.  When you are done, the screen automatically reverts to the main screen.  Remember that 
when you use this feature, the “Security Option” line in BIOS FEATURES SETUP will 
determine when entering the password will be required. 

To disable the password, press the <Enter> key instead of entering a new password when the 
“Enter Password” in the dialog box appears. A message will appear confirming that the 
password is disabled. 

 

If you have set both supervisor and user password, only the supervisor password allows you to 
enter the BIOS SETUP PROGRAM. 

Note :  If you forget your password, the only way to solve this problem is to discharge the 
CMOS memory  

Pressing <Enter> on this item asks for confirmation: 

Pressing “Y” stores the selections made in the menus in CMOS – a special section of 
memory that stays on after you turn your system off. The next time you boot your 
computer, the BIOS configures your system according to the Setup selections stored in 
CMOS. After saving the values the system is restarted again.