Lanner electronic FW-6420 Manuale Utente
Chapter 3
Award BIOS Setup
Award‘s ROM BIOS provides a built-in Setup program that allows users to modify the basic
system configuration and settings. The modified data will be stored in a battery-backed CMOS
RAM so that this data will be retained even when the power is turned off. In general, the
information saved in the CMOS RAM remains unchanged unless there is a configuration
change in the system, such as hard drive replacement or new equipment installment.
system configuration and settings. The modified data will be stored in a battery-backed CMOS
RAM so that this data will be retained even when the power is turned off. In general, the
information saved in the CMOS RAM remains unchanged unless there is a configuration
change in the system, such as hard drive replacement or new equipment installment.
3.1 Running AWARD BIOS
The Setup Utility is stored in the BIOS ROM. When the power of the computer system is
turned on, a screen message will appear to give you an opportunity to call up the Setup Utility
while the BIOS will enter the Power On Self Test (POST) routines. The POST routines
perform various diagnostic checks while initializing the board hardware. If the routines
encounter an error during the tests, the error will be reported in one of two ways, a series of
short beeps or an error message on the screen. There are two kinds of errors, fatal and non-fatal.
The system can usually continue the boot up sequence with non-fatal errors. Non-fatal error
messages usually appear on the screen along with the following instructions:
turned on, a screen message will appear to give you an opportunity to call up the Setup Utility
while the BIOS will enter the Power On Self Test (POST) routines. The POST routines
perform various diagnostic checks while initializing the board hardware. If the routines
encounter an error during the tests, the error will be reported in one of two ways, a series of
short beeps or an error message on the screen. There are two kinds of errors, fatal and non-fatal.
The system can usually continue the boot up sequence with non-fatal errors. Non-fatal error
messages usually appear on the screen along with the following instructions:
“ Press <F1> to RESUME ”
Write down the message and press the F1 key to continue the boot up sequence. After the
POST routines are completed, the following message appears:
POST routines are completed, the following message appears:
“ Press DEL to enter SETUP ”
Entering Setup
Turn on the power of the computer system and press <Del> immediately. If you don’t have the
chance to respond, reset the system by simultaneously pressing the <Ctrl>, <Alt> and <Delete>
keys, or by pushing the ‘ Reset ’ button on the system cabinet. You can also restart by turning
the system OFF then ON.
chance to respond, reset the system by simultaneously pressing the <Ctrl>, <Alt> and <Delete>
keys, or by pushing the ‘ Reset ’ button on the system cabinet. You can also restart by turning
the system OFF then ON.