LandAirSea Systems GPS Receiver 7100 Manuale Utente

USER’S GUIDE

LandAirSea 7100 Real Time GPS Tracking System

The LandAirSea 7100 is a web-based real time tracking system that uses GPS technology to
accurately determine the exact location of your vehicle.

You can set the unit to update its location while the vehicle is moving and can be set to update

in the following increments : 5, 15, 30, 60 minutes, 4 hours, daily or weekly.  If you do not need

the tracking unit to update automatically you can set it up for Web Poll which means you track
the location on an as needed basis.

The unit also has 3 inputs which can be connected to your vehicle’s alarm system or airbag
inflation system to inform you if your alarm is going off or if your airbag was inflated.

You can also use the LandAirSea 7100 to disable your vehicle from driving anywhere in the

event that it was stolen. The LandAirSea 7100 is very easy to install on your vehicle. It comes

with a single antenna and a power cable that connects directly to your battery or fuse box.

The very first thing you need to do is activate your tracking unit.  You do not want to have

your unit installed before it is activated. Activate it first.

You should have a 7100 Activation sheet that came with your tracking unit.  Fill it out

completely and fax it to the number given on the sheet.  Within 24 hours your unit will be

activated, usually activation will be completed in less than 2 hours.  You can check on the

status of your activation by trying to log in (See the section on Log In).  If you cannot log in,

than your unit probably has not been activated.

On the back of the tracking unit you will see eight small switches.  These switches control how

the unit will automatically report its’ location.  Make sure this is done before installation.

For most cases, switches 1, 2, 3, and 4 will not be used and can remain in the off position.

Later sections of this manual discuss the operation of switches 1-4.

Switch 5 controls whether or not the tracking unit will send Speed and Direction information

along with the location.  If you want the unit to report the speed and direction, then turn
Switch 5 OFF.  If you only need position (more economical) then turn Switch 5 ON.