Integra DTA-70.1 Manuale Utente

8

a Power switch

This is the main power switch. When set to OFF, 
the amplifier is completely shutdown. It must be set 
to On to set the amplifier to On or Standby.

b On/Standby button

This button is used to set the amplifier to On or 
Standby.

Note:
If you wish to turn on the amplifier again after it is turned 
off, wait for several seconds.

c Standby indicator

The amplifier is in standby state and waits for 
instruction signal from the 12V TRIGGER IN ter-
minal.

d On indicator

The main power of the amplifier is turned on and 
you can play and enjoy an input source.

Notes:
• If the Power switch is pressed and both of the On and 

Standby indicators do not light, check that the power 
cord is properly connected. If the indictors still do not 
light, turn off the amplifier, disconnect the power cord 
from wall outlet, and contact the dealer from whom 
you purchased this unit.

• If the Standby indicator flashes red, the protection cir-

cuitry of the amplifier has activated. The protection 
circuitry activates if a problem such as a speaker cable 
shorting or excessive temperature occurs. Turn off the 
amplifier, remove the cause of the problem, and then 
turn it back on. If the problem is still not solved, turn 
off the amplifier, disconnect the power cord from wall 
outlet, and contact the dealer from whom you pur-
chased this unit.

b c

d

a

DTA-70.1_En_100108.book  Page 8  Friday, January 8, 2010  2:04 PM