iHome id50 Manuale Utente

5

Connect the AC adaptor cable plug into the DC jack on the back of the system, then plug the AC cord of the AC adaptor 
into the wall outlet. Adaptor must be plugged in to operate unit. The unit does not operate on battery (a battery back up 
system maintains clock settings during power failures).

For best performance, make sure to update the iD50 firmware. To do so, download the free iHome Set app from the App 
Store. Launch the app, scroll to “Search for Update”, then follow directions to update the firmware.

Press the  Power/App Button on the unit at any time to turn the unit On or Off. Note that a docked iPad, iPhone or iPod 
will continue to charge when the unit is turned off as long as the AC adaptor is plugged in. 

The AutoSync feature automatically syncs the time setting on the unit to the time on your iPad, iPhone or recent model 
iPod (iPod touch, iPod nano and iPod Classic; older iPod models such as iPod mini do not support this feature). 
AUTOSYNC SETTING
By default, the unit is set to AUTOSYNC ON mode and will attempt to autosync the time whenever a capable iPad, iPhone 

or iPad is docked. 
To adjust autosync settings: Press and hold the Clock Button located on the top of the unit for 2 seconds. 
“AUTOSYNC ON” flashes on the display and a beep sounds. To turn autosync off, press and release theor Button 
while AUTOSYNC ON is flashing until “AUTOSYNC OFF” appears. This will disable autosync and allow you to set 
the time manually (see below).

1. Dock your iPad, iPhone or recent model iPod in the unit. In about 3 seconds, the unit will sync to your device. 
2. The unit will now autosync every time a capable iPhone/iPod or iPad is docked, and at 2AM each day. 
NOTE: iPhone time is automatically updated to the correct time via cell phone towers. The time on your iPad or iPod is 
accurate only to the time on the computer the last time the iPad/iPod was synced to it. It’s possible to have up to 59 seconds 
difference between the unit and synced iPad/iPhone/iPod.

Autosync must be OFF to set the clock manually.
1. Press and hold the Clock Button located on the top of the unit until “AUTOSYNC ON” or “AUTOSYNC OFF” flashes on 

the display,(if AUTOSYNC ON appears, press  the  or  Button to toggle to AUTOSYNC OFF setting).

2. Press and release the Clock Button. The time display will flash. Press the  or  Button to adjust the time (hold for 

a few seconds to advance or reverse rapidly). Remember to set the correct AM or PM hour. An icon in the upper left 
hand corner of the time display indicates AM or PM.

   (Note: if you wish to change the time display from the 12-hour format to the 24-hour format, sometimes called ‘military 

time’, press and release either the      or       Button to switch between 12-hour and 24-hour display formats.) 

3. Press the Clock Button again. The  year will flash in the lower part of the display.  Press the  or  Button until the 

current year is displayed.

4. Press the Clock Button again. The month and date will flash. Press the  or  Button until the current month and date 

is displayed. Hold to advance rapidly.

5. Press the Clock Button once more. Two beeps will sound to confirm your settings and you will exit Time and Calendar 

Setting mode.

P8