IBM X220 Manuale Utente
Numeric error codes
Table 2. Numeric error codes
Symptom or error
FRU or action, in sequence
0175
Bad CRC1, stop POST task—The EEPROM checksum is
not correct.
Bad CRC1, stop POST task—The EEPROM checksum is
not correct.
System board.
0176
System Security—The system has been tampered with.
System Security—The system has been tampered with.
1. Run the ThinkPad Setup program, and save the
current setting by pressing F10.
2. System board.
0177
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
System board.
0182
Bad CRC2. Enter the ThinkPad Setup program and load
Setup defaults.—The checksum of the CRS2 setting in
the EEPROM is not correct.
Bad CRC2. Enter the ThinkPad Setup program and load
Setup defaults.—The checksum of the CRS2 setting in
the EEPROM is not correct.
1. Run the ThinkPad Setup program. Press F9, and
Enter to load the default setting. Then save the
current setting by pressing F10.
current setting by pressing F10.
2. System board.
0185
Bad startup sequence settings. Enter the ThinkPad Setup
program and load Setup defaults.
Bad startup sequence settings. Enter the ThinkPad Setup
program and load Setup defaults.
1. Run the ThinkPad Setup program. Press F9, and
Enter to load the default setting. Then save the
current setting by pressing F10.
current setting by pressing F10.
0187
EAIA data access error—The access to EEPROM is failed.
EAIA data access error—The access to EEPROM is failed.
System board.
0188
Invalid RFID Serialization Information Area.
Invalid RFID Serialization Information Area.
System board.
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
System board.
0190
Critical low-battery error
Critical low-battery error
1. Charge the battery pack.
2. Battery pack.
2. Battery pack.
0191
System Security—Invalid Remote Change requested.
System Security—Invalid Remote Change requested.
1. Run the ThinkPad Setup program, and then save
current setting by pressing F10.
2. System board.
0192
System Security— Embedded Security hardware tamper
detected.
System Security— Embedded Security hardware tamper
detected.
System board.
0193
RF antenna has been removed
RF antenna has been removed
Enter the supervisor password.
0194
The computer has been carried through a security gate
The computer has been carried through a security gate
Enter the supervisor password.
0195
Security hardware tamper detected
Security hardware tamper detected
1. Enter the ThinkPad Setup program by entering
supervisor password, and select Password ➙
Security Chip ➙ Clear Security Chip to clear this
error.
Security Chip ➙ Clear Security Chip to clear this
error.
2. Security chip.
3. System board.
3. System board.
0196
Security hardware removed
Security hardware removed
1. Enter the ThinkPad Setup program by entering
supervisor password, and select Password ➙
Security Chip ➙ Clear Security Chip to clear this
error.
Security Chip ➙ Clear Security Chip to clear this
error.
2. Security chip.
3. System board.
3. System board.
Chapter 4
.
Related service information
43