Hotbrick VPN 800 / 2 Manuale Utente

HotBrick Network Solutions 

•  Enable – Use this to enable your Load Balance settings. Unless this is 

checked, the other settings on this screen have no effect. 

•  Balance Type – Select the desired option: 

•  Bytes rx+tx – Traffic is measured by Bytes. 
•  Packets rx+tx – Traffic is measured by Packets. 
•  Sessions established – Traffic is measured by Sessions. 
•  IP Address – Traffic is measured by IP Address. 

•  Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent 

over WAN 1. If one WAN port connection has greater bandwidth than the 
other, the one with the greater bandwidth should be given a higher percentage 
of traffic than the other. 

Click the "Update" button to save your changes. 

This section displays the current data about WAN 1 and WAN 2. You can use this 
information to help you "fine-tune" the settings above. 

This section displays cumulative statistics.  

Use the "Restart Counters" button to restart these counters when required. 

•  Update  – Save the settings on this screen. 
•  Refresh – Update the data on screen. 
•  Restart Counters – Restart the counters used in the "Interface Statistics" 

section. 

Page 21