Hotbrick LoadBalancer LB-2 Manuale Utente

HotBrick Network Solutions 

 

 

1.  Ensure the HotBrick Load Balancer LB-2 and the DSL/Cable modem are powered OFF. 

Leave the modem or modems connected to their data line. 

2.  Connect the Broadband modem or modems to the Load Balancer LB-2. 

•  If using only one (1) Broadband modem, connect it to the "WAN 1" port. 
•   Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a 

standard cable. 

3.  Use standard LAN cables to connect PCs to the Switching Hub ports on the Load Balancer.  

•  Both 10BaseT and 100BaseT connections can be used simultaneously. 
•  If you need to connect the Load Balancer LB-2 to another Hub, just use a standard LAN cable 

to connect any port on the Load Balancer LB-2 to a standard port on another hub. Any LAN 
port on the Load Balancer LB-2 will automatically act as an "Uplink" port when required. 

4. Power 

Up 

•  Power on the Cable or DSL modem or modems. 
•  Connect the supplied power adapter to the Load Balancer LB-2 and power up. 

5.  Check the LEDs 

•  The Power LED should be ON. 
•  The WAN – Link LED should be ON, if the corresponding WAN port is connected to a 

broadband modem. 

•  The Error LED will flash during start up, but will then turn off. If it stays on, there is an error 

condition. 

  

12