HP FIBRE CHANNEL TO SCSI ROUTER M8201R Manuale Utente

Hardware Replacement Procedures

M8201R Fibre Channel to SCSI Router Installation and User’s Guide — 529971-005

Fibre Channel to SCSI Router Replacement

3. Unplug the power cord from the AC power outlet, and then unplug the other end 

from the tape drive’s AC power receptacle. 

4. Disconnect the SCSI cable from port 1 by unscrewing the screws by hand. Do not 

use a screwdriver.

5. Disconnect the differential terminator from port 2 by unscrewing the screws by 

hand. Do not use a screwdriver.

6. Place the old tape drive aside.

7. Connect the new tape drive. Refer to section 3 

 when installing a new tape drive.

8. Power cycle the Fibre Channel to SCSI router by powering it off and then on.

9. Start the tape drive in SCF by entering in the following command:

SCF> START TAPE $TAPE1

1. Perform a forced reset on the tape drive in SCF by entering in the following 

command:

SCF> RESET TAPE1, FORCED

2. Power off the tape drive by pressing the power switch. See 

 for the 

location.

3. Power off the Fibre Channel to SCSI router. 

4. Unplug the power cord from the AC power outlet, and then unplug the other end 

from the AC power receptacle on the Fibre Channel to SCSI router. 

5. Disconnect the fiber cable from the small form-factor pluggable (SFP) on the unit.

6. Disconnect the SCSI cable from the Fibre Channel to SCSI router on port 0. If 

there is another tape drive connected to port 1, disconnect that device also.

Small Form-Factor 
Pluggable (SFP)