Hitachi 8000 Elite Manuale Utente
3.
Turn off the computer properly through the operating system, then turn off any external devices.
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
Regardless of the power-on state, voltage is always present on the system board as
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
avoid damage to the internal components of the computer.
5.
Remove the computer access panel.
6.
Install four 6-32 isolation mounting guide screws, two on each side of the drive.
Figure 2-26
Installing the Hard Drive Guide Screws
NOTE:
The hard drive uses 6-32 isolation mounting guide screws. Eight extra guide screws are
installed on the hard drive bracket under the access panel. The HP-supplied isolation mounting
guide screws are silver and blue. Refer to
guide screws are silver and blue. Refer to
for an illustration
of the extra 6-32 isolation mounting guide screws location.
If you are replacing a drive, transfer the guides screws from the old drive to the new one.
7.
Slide the hard drive down into the drive cage until it locks. The drivelock automatically secures the
drive in the bay.
drive in the bay.
Figure 2-27
Installing a Hard Drive into the Hard Drive Bay
CAUTION:
Make sure the guide screws line up with the guide slots in the drive cage. The use of
unnecessary force when installing any drive into the drive bay may result in damage to the drive.
ENWW
Installing Additional Drives
33