Hach sc1000 Manuale Utente

1. Strip the insulation from the communication cable (

2. Feed the cable through the union nut, rubber seal, and connector housing 

(

3. Connect the cable to the network connector circuit board as shown in 

. 

Network Connector Assembly
4. Place the circuit board with the cable connected in the bottom part of the metal 

frame.

5. Tighten the cable connector.

6. Place the top of the metal frame on the bottom and press together. 

7. Feed the frame into the sc1000 connector. The frame will only fit in one position. If 

necessary, rotate the frame.

8. Attach the circuit board and the frame to the front with the two self-tapping screws 

provided.

Figure 28 Plugging the network connector to the network interface

Probe module

sc1000 network connector 

sc1000 network interface

sc1000 network interface cover