Garmin Dash Cam 10/20 Manuale Utente

See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

The device supports microSD™ and microSDHC memory cards.

Insert a memory card into the slot on the device.

Press it in until it clicks.

Before you can use or turn on the device, you must install a 

memory card.
You can power and charge the device using vehicle power.
TIP: You should fully charge the device before you use the 

device on battery power.

With the vehicle off, plug the power cable into a power outlet 

in your vehicle.

Plug the other end of the power cable into the USB port on 

the device.

Press the device 

À

 onto the suction cup 

Á

.

Press the suction cup to the windshield, and flip the lever 

 

back toward the windshield.

NOTE: The device should be installed on the windshield as 

shown. Installing the device in a sideways or upside-down 

orientation results in sideways or upside-down video 

recordings.

Turn on the vehicle.
When the device is connected to an ignition-switched power 

outlet, it turns on automatically when you turn on the vehicle.

Before you turn on the device using battery power, you should 

fully charge the battery (

).

NOTE: When the device is connected to an ignition-switched 

power outlet, it turns on automatically when you turn on the 

vehicle.

Select  .

The device turns on.

NOTE: When the device is connected to an ignition-switched 

power outlet, it turns off automatically when you turn off the 

vehicle.

Select  .

The device turns off.

The device immediately begins recording video when it turns 

on, and it continues recording, overwriting the oldest, non-

protected videos until it turns off. While recording, the LED 

below the screen is solid red.
NOTE: The device records continuously until it turns off.

By default, the device uses a sensor to automatically detect 

accidental collisions and protect the three video files during, 

before, and after the detection. At 1080p, the video files are 

approximately four minutes long.
NOTE: You must calibrate the event detection sensor from the 

).

You can also manually protect video files at any time.

While recording, select  .
The device protects the current, previous, and next video 

files.

You can take still photographs with this device.

While recording, select  .
The device takes a photo and saves it to the memory card.

NOTE: The device stops recording video while you view videos 

or photos.

Select  .

Select an option:
• Select Video to view videos.
• Select Snapshot to view photos.

Select a video or photo to view.

Select  .

You can connect the device to your computer to view, transfer, 

or delete videos and photos stored on the device memory card 

(

).

• Videos are stored in the GARMIN\Video folder on the device.
• Photos are stored in the GARMIN\SnapShot folder on the 

device.

Getting Started

1