CyberResearch FPC 1702-P30 Manuale Utente

These routines test and initialize board hardware. If the routines encounter 

an error during the tests, you will either hear a few short beeps or see an 

error message on the screen. There are two kinds of errors: fatal and non-

fatal. The system can usually continue the boot up sequence with non-fatal 

errors. Non-fatal error messages usually appear on the screen along with the 

following instructions: 

Press <F1> to RESUME 

Write down the message and press the F1 key to continue the boot up 

sequence. 

These routines check the current system configuration against the values 

stored in the CMOS memory. If they do not match, the program outputs an 

error message. You will then need to run the BIOS setup program to set the 

configuration information in memory. 

There are three situations in which you will need to change the CMOS 

settings: 

1.  You are starting your system for the first time 

2.  You have changed the hardware attached to your system 

3.  The CMOS memory has lost power and the configuration 

 
 

42 

25 Business Park Drive 

 

P: (203) 483-8815; F: (203) 483-9024 

Branford, CT USA 

 

www.cyberresearch.com