Futaba 10CAG Manuale Istruttivo

16

<RXPD\DGMXVWWKHWHQVLRQRI\RXUVWLFNVWRSURYLGHWKHIHHOWKDW\RXSUHIHUIRUÀ\LQJ7RDGMXVW\RXUVSULQJV\RX¶OOKDYH
to remove the rear case of the transmitter. First, remove the battery cover on the rear of the transmitter. Next, unplug the 
battery wire, and remove the battery from the transmitter. Next, using a screwdriver, remove the four screws that hold the 
transmitter’s rear cover in position, and put them in a safe place. Gently ease off the transmitter’s rear cover. Now you’ll 
VHHWKHYLHZVKRZQLQWKH¿JXUHDERYH

Using a small Phillips screwdriver, rotate the adjusting screw for each stick for the desired spring tension. The tension 
increases when the adjusting screw is turned clockwise. 

:KHQ\RXDUHVDWLV¿HGZLWKWKHVSULQJWHQVLRQVUHDWWDFKWKHWUDQVPLWWHU VUHDUFRYHU:KHQWKHFRYHULVSURSHUO\LQSODFH
reinstall and tighten the four screws. Reinstall the battery and cover. 

To adjust the display contrast, from the home menu press and hold the END BUTTON.
Turn the DIAL while still holding the END BUTTON:

clockwise to brighten 
counterclockwise to darken the display 

Let go off the DIAL and the END BUTTON.

You may change the length of the control sticks to make your transmitter more 
comfortable to hold and operate. To lengthen or shorten your transmitter’s 
VWLFNV¿UVWXQORFNWKHVWLFNWLSE\KROGLQJORFNLQJSLHFH%DQGWXUQLQJVWLFNWLS
A counterclockwise. Next, move the locking piece B up or down (to lengthen 
or shorten). When the length feels comfortable, lock the position by turning 
locking piece B counterclockwise. 

Stick tip  A

Locking piece  B

Mode 2 transmitter with rear cover removed.

Aileron

Elevator

Rudder

Stick

Stick