Futaba 10CAG Manuale Istruttivo
82
AILE-FLAP
(GLID 2A+2F only):
Adjustability:
• RATE
• RATE
UDQJHRIWR1HJDWLYHVHWWLQJZRXOGUHVXOWLQRSSRVLWHDLOHURQDFWLRQIURPÀDSV
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up LOGIC SW: See p. 38.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
positions of the same SWITCH.
• Condition: The separate AILE-FLAP
VHWWLQJVIRUHDFKÀLJKWFRQGLWLRQFDQEHVHW
GOAL of EXAMPLE:
STEPS:
INPUTS:
Turn on AILE-FLAP mixing. Set rate
to100% for maximum possible flap
travel with ailerons. Assign to SWITCH
C center.
to100% for maximum possible flap
travel with ailerons. Assign to SWITCH
C center.
Open AILE-FLAP submenu.
for 1 second.
(If BASIC,
again.)
to 2nd page of menu.
C
to AILE-FLAP.
Activate the function.
C
to MIX
to ON.
Set the rate. (Ex: 100% each way)
C
to FLP1.
AILERON STICK.
to +100%.
AILERON STICK.
to +100%.
Repeat above to set FLP2.
Assign the SWITCH and position.
C
to SW.
to C.
C
to POSI.
to CENTER.
Close.
Where next?
ELEV-FLAP
mixing. See p. 62.
BUTTERFLY
. See p. 63.
Use a mix to OFFSET
WKHÀDSVDVHWGLVWDQFHRQDVSHFL¿HGVZLWFK VHHS
View additional model setups on the internet: www.futaba-rc.com\faq\
This pre-programmed mix is used to create full span aileron action on a glider
with 4wing servos. This increases the roll rate and decreases induced drag.
)RUQRUPDOÀ\LQJDYDOXHRIDERXWLVRIWHQXVHG)RUVORSHUDFLQJRU)%
models in speed runs, you may wish to use a larger value approaching 100%.
with 4wing servos. This increases the roll rate and decreases induced drag.
)RUQRUPDOÀ\LQJDYDOXHRIDERXWLVRIWHQXVHG)RUVORSHUDFLQJRU)%
models in speed runs, you may wish to use a larger value approaching 100%.