Force10 Networks S2410s Manuale Utente
96
System Management Commands
show trapflags
show trapflags
This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is
detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch
does not have to be reset to implement the changes. Cold start traps are always generated and
cannot be disabled.
enabling or disabling the trap condition. If a trap condition is enabled and the condition is
detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch
does not have to be reset to implement the changes. Cold start traps are always generated and
cannot be disabled.
Syntax
show trapflags
Mode
Privileged Exec
Table 16 Fields of show snmptrap
Command Report
Field Description
SNMP Trap Name
The community string of the SNMP trap packet sent to the trap manager. This
may be up to 16 alphanumeric characters. This string is case sensitive.
may be up to 16 alphanumeric characters. This string is case sensitive.
IP Address
The IP address to receive SNMP traps from this device. Enter four numbers
between 0 and 255 separated by periods.
between 0 and 255 separated by periods.
Status
Indicates the receiver's status (enabled or disabled)
Note: The DVMRP, OSPF, and PIM traps are not supported in the Layer 2 image.
Table 17 Fields of show trapflags
Command Report
Field Description
Authentication Flag
May be enabled or disabled. The factory default is enabled. Indicates whether
authentication failure traps will be sent.
authentication failure traps will be sent.
Link Up/Down Flag
May be enabled or disabled. The factory default is enabled. Indicates whether
link status traps will be sent.
link status traps will be sent.
Multiple Users Flag
May be enabled or disabled. The factory default is enabled. Indicates whether a
trap will be sent when the same user ID is logged into the switch more than once
at the same time (either via telnet or serial port).
trap will be sent when the same user ID is logged into the switch more than once
at the same time (either via telnet or serial port).
Spanning Tree Flag May be enabled or disabled. The factory default is enabled. Indicates whether
spanning tree traps will be sent.
DVMRP Traps
May be enabled or disabled. The factory default is disabled. Indicates whether
DVMRP traps will be sent.
DVMRP traps will be sent.
OSPF Traps
May be enabled or disabled. The factory default is disabled. Indicates whether
OSPF traps will be sent.
OSPF traps will be sent.
PIM Traps
May be enabled or disabled. The factory default is disabled. Indicates whether
PIM traps will be sent.
PIM traps will be sent.