Flowmatic Water System FMR04-ZW Manuale Utente
Operational Parameters
Do not use with water that is microbiologically unsafe or of unknown quality, without
adequate disinfection before or after the system.
adequate disinfection before or after the system.
Operating Temperatures:
Maximum 100°F (37.8°C)
Minimum 40°F ( 4.4°C)
Operating Pressure:
Maximum 100 psi (7.43 g/cm2) Minimum 40 psi (2.80 kg/cm2)
pH Parameters:
Maximum
11
Minimum
3
Iron:
Maximum 0.2 ppm
TDS (Total Dissolved
Solids):
Solids):
< 1000 ppm
Turbidity:
<5NTU
Hardness: Recommended hardness not to exceed 7 grains per gallon, or 120ppm. System will
operate with hardness over 7 grains but the membrane life may be shortened. Addition of a water
softener may lengthen the membrane life.
operate with hardness over 7 grains but the membrane life may be shortened. Addition of a water
softener may lengthen the membrane life.
Note: RO unit must be installed a mimimun of 25 feet from hot water heater.
FMRO4-ZW System
System includes:
RO module, 24 volt Pump, 3 gal Storage tank, Long reach
faucet, Manual, Warranty Card, Parts Bags, (2 Water line
fitting valves, 2 Washers,Transformer, 2 Mounting screws, 1
Teflon tape roll, 2 Brass inserts, 2 Plastic sleeves, 1 Ball
val
RO module, 24 volt Pump, 3 gal Storage tank, Long reach
faucet, Manual, Warranty Card, Parts Bags, (2 Water line
fitting valves, 2 Washers,Transformer, 2 Mounting screws, 1
Teflon tape roll, 2 Brass inserts, 2 Plastic sleeves, 1 Ball
val
ve,
one
1/
4”
Connect
or
)
Tools recommended for installation
7/
16”Drill bit for faucet
Channel lock piers
Phillips Screw Driver
1/2" - 5/8" Open End Wrench
Adjustable Wrench
Sharp knife
Electric Drill
Phillips Screw Driver
1/2" - 5/8" Open End Wrench
Adjustable Wrench
Sharp knife
Electric Drill
3