Chicago Electric 96531 Manuale Utente

Page 10

SKU 96531

note:  For additional information regarding the parts listed in the following pages, refer 

to the Assembly Diagram near the end of this manual.

Match up holes in Plug (27) to pins in Cord Connection (6), plug in, and secure 

with Cord retainer (26).  
Place Sponge in the bottom of the handle rest  

unit.
Set up handle rest unit within easy reach 

of the Soldering Station.
Plug Soldering Station into any standard, 

120V AC electrical outlet.

The Digital Soldering Station is designed to heat 

solder in order to secure wiring and metal surfaces together.

Check for breakage, worn parts, damaged cords, or any other condition that may 

effect the tool’s operation.  If damaged, have the tool serviced by a qualified tech-

nician before using.
Tighten the Tip retainer (16) on the Soldering Iron (15).
Select the correct solder for the intended application.  read the directions for the 

solder being used to determine what temperature level to set on the Soldering 

Station.  To minimize the risk of damage to surrounding components, select the 

minimum heat required to melt the solder chosen for the application. 
Plug Soldering Station in and turn Power Switch (4) to the “ON” position.  Turn 

the Temperature Dial () and wait until the desired temperature is displayed on 

the LCD Display (5) or push one of the Preset Buttons. 

Preset Button 1 = 150ºC (302ºF)
Preset Button 2 = 270ºC (51ºF)
Preset Button 3 = 360ºC (60ºF)

1.

2.

3.

4.

1.

2.
3.

4.

•
•
•

handle rest (when cold)