Chauvet Camera Accessories ST-200 Manuale Utente
Setup
ST-200 User Manual
6
Revision: 2004-11-02/11:23
Figure 1 - Hanging Bracket
Note!
Clamp is sold separately.
Clamp is sold separately.
Mounting
O R I E N T A T I O N
This fixture may be mounted in any position provided there is adequate room for ventilation. It is also
possible to stand this fixture using the removable feet provided.
R I G G I N G
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding
the desired position, retighten both knobs.
•
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
replacement access and routine maintenance.
•
Safety cables should always be used.
•
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
humidity, extreme temperature changes or restricted ventilation.
Using a Color Gel
The ST-200 is equipped with a detachable clear front cover that doubles as a gel holder as illustrated
below.
1)
Open the clear lamp cover by removing the thumbscrew.
2)
Cut a piece of gel filter to match the size of the cover or slightly
larger. The size of the gel used in the illustration was a 6.5” by
6.5”.
larger. The size of the gel used in the illustration was a 6.5” by
6.5”.
3)
Lay the gel over the opening, close cover and replace the
thumbscrew securely.
thumbscrew securely.