Aztech DSL5018EN Manuale Utente
U s e r M a n u a l
16
To add a WAN interface:
1.
Select an available Virtual Circuit from the drop-down box
2.
Enter VPI/VCI settings (provided by your ISP)
3.
Input QoS settings (provided by your ISP)
4.
Select the IPv4/IPv6 version
5.
Select the WAN Connection Type
6.
For PPP enter PPP Username and Password (provided by your ISP)
7.
Bridge Interface should be deactivated.
8.
Connection Setting should be ‘Always on’.
9.
Ensure Default Route is selected as Yes
10. Ensure Get IP Address is set to Dynamic
11. Ensure NAT is ‘Enable’.
12. For IPv6 Option check with your Internet Service Provider the settings required.
13. Click the Apply button to commit the settings
11. Ensure NAT is ‘Enable’.
12. For IPv6 Option check with your Internet Service Provider the settings required.
13. Click the Apply button to commit the settings
To edit an existing WAN interface:
1.
Select the Virtual Circuit that you want to Edit from the drop down box
2.
Make the necessary amendments
3.
Click the Apply button to commit the settings