Avaya CM160 Dépliant

Safety Precautions
Do not reposition the pedestal while driving.  Arkon Resources, Inc. 
does not promote the adjustment of hand-held devices except when 
the vehicle is safely parked or stopped. 

Arkon is not responsible for any damages caused to your car, your 
device, or yourself due to the installation or use of the pedestal mount. 

Arcadia, CA 91006 USA

Made in Taiwan

© Copyright 2007 Arkon Resources, Inc.

Consumer Hotline:
(USA)    (800) 841-0884
(INT’L)   (626) 254-9005
                Mon-Fri. 9am-5pm, PST

CM160  |  Universal Mobile Phone Vent Mount

Package Contents:
(1) CM030 Universal Mobile Phone Cradle
(1) CM047-S Vent Mount Assembly

NOTES:
1. This vent mount kit is designed for 
permanent and semi-permanent use 
only. This assembly can be diffi

  cult 

to remove from your vent louvres. Be 
careful if removing the vent assembly.  

2. This vent mount kit is not compatible 
with circular air vents.

Choose a suitable vent location for 
installation.  Attach the vent mounting 
clips to the back of the pedestal with 
the vent clips correctly positioned with 
the fl at sides facing up.

Gently insert vent pedestal into vent 
louvres until the mounting clips are 
attached to the fi n/blade of the vent. 
Adjust the spacing between the 
mounting clips if necessary. 

Warning: Arkon is not responsible if 
the vent louvres become damaged 
as a result of the installation or use of 
this mount.

Step 1. 

Step 2.

CM047-S Vent Mount Pedestal
(fully assembled)

CM030 Universal 
PDA/MP3 Cradle

Adjust the support leg vertically until 
it rests fi rmly along the bottom of the 
vent or dash surface below the vent. It 
will need to support the weight of the 
cradle and device. 

If necessary, move the support leg to 
the alternate bracket holes.

If necessary, you can rotate the lateral 
head by holding the swivel mechanism 
and gently pulling and rotating the 
head to the desired angle .

Warning: Do not attempt to pull out 
the lateral head to rotate without fi rst 
holding the pedestal for support. 
Pulling on the head and assembly can 
damage your louvres. 

Step 3. 

Step 4.

While holding the pedestal’s swivel 
mechanism, align the T-tab on the 
pedestal face to the T-slot on the back 
of the cradle and slide down. 

Warning: The vent mount assembly can 
be diffi

  cult to remove from your vent 

louvres.

Remember to use the utmost care when 
trying to remove the vent assembly so as 
not to damage your vehicle.

Remove the cradle from the vent mount 
assembly. 

Carefully slide the mounting clips inward 
as close together as possible to help 
remove the pedestal from the clips at the 
center hole. 

Carefully pinch the clip and angle the 
clip off  of the vent fi n/blade. 

If are unable to remove the vent mount 
clips, please call our technical service 
department at (626) 254-9005.

Step 5. 

Step 1.

Step 2.

Step 3.

Step 4.

Step 5.

Mounting clip

Mounting clip

Spring-loaded 
swivel mechanism

Lateral 
head

Rotate

Swivel

T-slot

Cradle back

Support leg

T-Tab