Autodesk Z800 Manuale Utente
Connecting the Autodesk Control Surface to a Lustre
Workstation
Workstation
The Autodesk Control Surface consists of three panels connected to the workstation’s on-board GigE port 1
by way of the supplied network switch. The central panel requires an additional connection to the remote
unit of the USB extender kit.
by way of the supplied network switch. The central panel requires an additional connection to the remote
unit of the USB extender kit.
This section provides information on making the physical connections needed to operate the Autodesk
Control Surface. For information on using the Control Surface, see the Autodesk Control Surface User Guide.
Control Surface. For information on using the Control Surface, see the Autodesk Control Surface User Guide.
1
3
4
5
6
7
8
PWR
NETGEAR
2
Autodesk Control Surface
5V DC 4A
Ethernet
Autodesk
Tablet
S
ystem
P
ower
Link
Activit
y
-
+
Network Switch
To USB extender
Ports 3 and 4 to
additional panels
additional panels
To port 1 on USB Extender
HP Z800 Workstation
NOTE The illustration shows the central panel only (the Colour Grading panel). This panel is easily identified,
since it has both an Ethernet network port and a USB connector. It is also the panel with the built-in tablet.
since it has both an Ethernet network port and a USB connector. It is also the panel with the built-in tablet.
To connect the Autodesk Control Surface:
1 Connect each panel to a power supply using the AC power adapter cables.
18 | Chapter 3 Connecting Peripherals