Aton DLA6 Manuale Utente
© 2008 • All rights reserved. 13
DLA2/4/6 Speaker Level Audio Router
3. Connections
AMPLIFIER INPUT
Use 16 AWG stranded copper speaker wire to connect from a speaker level output of an A/V
receiver, stereo receiver, or amplifer. Turn power for the output device OFF before making
connections.
receiver, stereo receiver, or amplifer. Turn power for the output device OFF before making
connections.
To make connections:
Cut the ends of the wire to length, allowing some free play (about 6 inches
1.
of slack) to allow for movement when physically connecting the wire.
Using wire strippers, remove 3/8 inch of insulation, then twist the wire to
2.
ensure that no stray strands are evident.
De ne positive (
3.
+) and negative (-) at the ampli er end and the DLA2/4/6
end of the wire run and use the same conductor on each end.
Lift up each ip-lock connector until it is locked in the up position.
4.
Place the bare lead from each speaker wire from the receiver/ampli er
5.
into the holes of the Ampli er Inputs terminal of the DLA2/4/6, maintaining
the polarity of each lead (+ to +, - to -).
Note: To avoid damage to the receiver/ampl er, DO NOT allow speaker leads to touch
each other.
each other.
CLASS 2 WIRING
AMPLIFIER
INPUT
Speaker
Cables
Receiver/Amplifier
Output
DLA2/4/6
+
-
L
L
R
R
B
A
Figure 3-1: Receiver/Ampli er Output to DLA2/4/6 Ampli er Input
125 Watts
per Channel
Max