Atomic Amplifiers 112 Manuale Utente
9
Desktop Modeler in Stereo
RETURN
SEND - L
EFFECTS
LOOP
SEND - R
MODEL REACTOR 112
Atomic Amplifiers LLC.
Orange CT.
FUSE
0101010101
!CAUTION!
RETURN
SEND - L
EFFECTS
LOOP
SEND - R
MODEL REACTOR 112
Atomic Amplifiers LLC.
Orange CT.
FUSE
0101010101
!CAUTION!
PLEASE NOTE!
*
If you wish to use a pair of
Reactors in MONO, simply
use the SEND – L output
instead of SEND – R.
Reactors in MONO, simply
use the SEND – L output
instead of SEND – R.
X
After obtaining the proper
template load your modeler
into the DS-1 that comes
provided with your Reactor
112 (see page 8).
template load your modeler
into the DS-1 that comes
provided with your Reactor
112 (see page 8).
Y
Load the DS-1 into the
docking bay located in the
top of Reactor #1, making
sure that the dock locks
click into position.
docking bay located in the
top of Reactor #1, making
sure that the dock locks
click into position.
Z
Install a blank template onto
the Reactor #2’s DS-1.
Then load the DS-1 back
into the Reactor.
the Reactor #2’s DS-1.
Then load the DS-1 back
into the Reactor.
(see page 10)
[
*
Run a standard shielded
1/4 inch cable from Reactor
#1’s Send R on the rear
panel to the Return on
Reactor #2’s rear panel.
1/4 inch cable from Reactor
#1’s Send R on the rear
panel to the Return on
Reactor #2’s rear panel.
\
If using a foot controller with
your modeler, connect it as
normal using the connector
access port located on the
rear of the reactor.
your modeler, connect it as
normal using the connector
access port located on the
rear of the reactor.
]
Turn on Reactor #1s
power switch (it should
light up). Your modeler
should power up at the
same time as the amp.
power switch (it should
light up). Your modeler
should power up at the
same time as the amp.
^
Turn on Reactor #2s power switch (it
should light up).
should light up).
_
Bring up the levels on your modeler and switch
to some of your favorite presets.
to some of your favorite presets.
Z
X
\
]
[
^
Y