Atlas Copco Stationary Air Compressors Manuale Utente
Instruction book
2920 1521 00
48
2. By pressing the
↓ key, a number of actually measured data can be found (see Fig. 8.1).
3. If one of the sensors is linked to a shut-down, service or warning function, both the actually
measured value as well as the corresponding shut-down, warning or service level can be called up
by pressing the tabulator key (5).
by pressing the tabulator key (5).
8.5 Counters menu
Function
To allow the operator to call up the:
- running
hours
-
regulator (module) hours (the hours the module has been under tension)
-
running hours per compressor module
-
starts per compressor module
-
shutdowns per compressor module
Procedure
1. Starting from the Main screen (see section 8.1.2):
-
press the key "Menu" (F1)
- press
the
↓ key until the option "Counters" is followed by a horizontal arrow
-
press the tabulator key (5) to activate the menu
2. By pressing the
↓ key, the above-mentioned data can be found (see also Fig. 8.1).
8.6 Test menu
Function
To carry out a display test, i.e. to check whether the display and LEDs are still intact.
Procedure
1. Starting from the Main screen (see section 8.1.2):
-
press the key "Menu" (F1)
- press
the
↓ key until the option "Test" is followed by a horizontal arrow
-
press the tabulator key (5) to activate the menu
2. The option "Display test" will be followed by a horizontal arrow.
3. After pressing the tabulator key (5), the regulator will generate a series of patterns on the display
3. After pressing the tabulator key (5), the regulator will generate a series of patterns on the display
which enable the operator to check that each pixel still functions normally; at the same time the
LEDs are lit.
LEDs are lit.