Asko WCAM 1812 Manuale Utente

I N S TA L L AT I O N   I N S T R U C T I O N S

Check for leaks at water faucet and 
machine before proceeding. Be sure 
the water taps are on before starting.

Before using washer/dryer, 
read owner’s manual 
thoroughly. Save all instructions 
for future reference. 

Wipe inside and outside of washer/dryer with a damp 
cloth before running to remove any dust or debris. 

Run your empty washer/dryer through a complete wash 
cycle before washing clothes. Check for water leaks and 
proper operation during this 
test run.

ASKO denies all liability if instructions are not followed 
correctly.

Water may be drained into a sink, drainpipe or standpipe. To prevent 
siphoning, do not seal drain hose into drain outlet. 

Wall or Floor Standpipe Drain System - The top of the standpipe 
must be between 23” (60 cm) - 35” (90 cm) from the bottom of the 
washer. 

You should securely attach drain hose to keep water pressure from 
allowing hose to come loose and leak on the floor. 

The front and rear legs may be screwed /unscrewed to level the 
machine. To access legs, tilt machine backwards until it rests against 
wall or other stable structure. Adjust legs up or down until washer is 
stable and does not rock front-to-back or side-to-side when upright. 
Once machine is level, tighten locknuts.

Plug power cord into grounded outlet only (see Grounding Instructions 
on page 3 for complete details). Be sure power is OFF at fuse box/
circuit breaker before plugging in machine for the first time. Plug cord 
into outlet and turn power on at circuit breaker.

A