ASA Electronics TVR6 Manuale Utente
54-0376
3.11
Using the Remote Control
8.
At the same time, press the MUTE button for two
seconds.
seconds.
9.
Release both buttons. The SAT button should
remain lit. If it doesn’t, repeat Steps 7-9.
remain lit. If it doesn’t, repeat Steps 7-9.
10. Enter the desired ID number (between “001” and
“008”) using the numeric keypad.
11. Press the SAT button to lock in the code.
12. Press the SELECT button twice.
The number to the right of the highlighted Remote
ID
ID
button will change to the new code. Check that
the ID has been set properly by testing the remote
control to ensure that it controls the receiver.
control to ensure that it controls the receiver.
3-4
Installing the Remote Control
Batteries
Batteries
To install or replace the remote control’s batteries,
follow the steps below.
follow the steps below.
1.
Remove the battery compartment cover, located
on the back of the remote control.
on the back of the remote control.
2.
Insert two AAA batteries as shown, observing the
correct polarity.
correct polarity.
3.
Replace the battery compartment cover.
Remote Control Batteries