Arkon MP070-7PS-1 Dépliant

Consumer Hotline: 
(USA)    (800) 841-0884
(INT'L)   (626) 254-9005
               Mon-Fri. 9am-5pm, PST

Arcadia, CA 91006 USA

Made in Taiwan

© Copyright 2007 Arkon Resources, Inc.

MP070-7PS-2

MP070-7PS-1 with a single T-tab is also available with the same set of 
instructions listed below. 

Step 1.

Step 2.

Locate a safe flat surface on 
the dash or console to mount 
the pedestal. Clean the dash 
with the alcohol pad 
provided. Dry the surface 
before applying the adhesive 
disc (C).

Push the pedestal suction cup 
(A) firmly to the disc (C). Flip 
the lever (B) down to secure 
the suction cup.

Dash Installation (Optional, 
when disc is included)

Step 1.

Windshield Installation  

Push the pedestal suction cup (A) firmly to the windshield. 
Flip the lever (B) down to secure the suction cup. 

Step 1.

.

Adjust the vertical angle of the pedestal shaft by 180

° and 

the swivel rotation by 360

° by loosening the adjustment 

knob (D). Adjust the lateral angle of the dual T-head (F) by 
180

° and the rotation by 360° by loosening the adjustment 

knob (E). 

Step 1. Attach the device cradle to the pedestal by inserting the dual T-

tabs (F) of the pedestal into the T-slots of the cradle (G). (cradles 
are sold separately and vary depending on the device you are using)

Pedestal 

Shaft

Do not install Arkon products over an air bag cover or within the air 
bag deployment zone. Arkon Resources, Inc. assumes no 
responsibility of liability for injury or death as a result of car crashes 
and/or air bag deployment.

Arkon Resources, Inc. is not responsible for any damages caused to 
your car, your device, or yourself due to the installation or use of the 
pedestal mount.