Alvarion BREEZEACCESS SW VERSION 5.1 Manuale Utente
Chapter 2 - Installation
BreezeACCESS VL System Manual
52
2.4
Installing the Universal IDU Indoor Unit
The unit can be placed on a desktop or a shelf. Alternatively, it may be
wall-mounted using the kit supplied with the unit.
wall-mounted using the kit supplied with the unit.
Figure 2-13: IDU PS 1073 Front Panel
The RADIO connector and RESET button are located on the front panel, the
ETHERNET connector is located on the side panel and LEDs are located on the
top panel.
ETHERNET connector is located on the side panel and LEDs are located on the
top panel.
CAUTION
Do not connect the data equipment to the RADIO port. The RADIO port supplies DC power to the
ODU, and this may harm other equipment connected to it.
ODU, and this may harm other equipment connected to it.
To install the IDU:
1
Connect the Indoor-to-Outdoor cable to the RADIO connector, located on the
front panel of the indoor unit.
2
Connect the power cord to the unit's AC socket, located on the rear panel.
Connect the other end of the power cord to the AC mains. The unit can
operate with AC mains of 100-240 VAC, 50-60 Hz.
operate with AC mains of 100-240 VAC, 50-60 Hz.
NOTE
The color codes of the power cable are as follows:
Brown
Phase ~
Blue
Neutral 0
Yellow/Green
Ground
3
Verify that the POWER LED is lit, indicating that power is supplied to the
unit.
4
Configure the basic parameters as described in section
3.1
.
5
Connect the 10/100 BaseT ETHERNET connector to the network. The cable
connection should be a straight Ethernet if connecting the indoor unit to a
hub/switch and a crossed cable if connecting it directly to a PC Network
Interface Card (NIC).
hub/switch and a crossed cable if connecting it directly to a PC Network
Interface Card (NIC).