ALDI CFT25 Manuale Utente

1.

Connect the charger plug to the charging jack or hole on the back of the 

sweeper. Plug the the charging adapter into the wall outlet. (120V., 60Hz.) Use only        

Charger AD-0815-U8. (Fig. 8) 

2.

This cordless sweeper is powered by Ni-Cd batteries.  Before first use, 

they must be charged for a minimum of 20  hours.

3.

When recharging the unit, the "On/Off" switch must be in the "OFF" position.

4.

The charging light indicator on the top of the sweeper will illuminate to indicate that 

the sweeper is properly charging.

5.

To recharge, repeat step #1 above. Charging times will vary depending upon 

the amount of usage between charging cycles.

Your Cordless Sweeper will require very little assembly. You should remove it 
from the carton and familiarize yourself with all the components listed per the 
exploded view drawing (pg.2) This will help you in the assembly and operation of 
your cordless sweeper.

Note: The charging adapter is shipped inside the dust cup.

Fig. 1

Captive Nut

Lower
Handle

Bolt

2. Assemble the metal extension handles by pushing the plastic insert into the mating             

metal tube. Push until only small portion of insert is visible or you cannot press any 
farther into the tubing. Push the handle assembly into the upper handle.
NOTE: One metal extension tube has a different plastic insert. This tube should 

Insert the handle assembly into the lower handle so that the tab on the plastic       
insert snaps into the open slot on the lower handle. (Fig. 2)                                                     

Insert into Lower 
Handle

Fig. 2

1. Insert the lower handle.  Fasten it with the captive nut and bolt that is provided.  

(Fig. 1)

Fig. 8

3. Place the handle into the upward storage position.

4. Plug the charging adapter into the sweeper power head charging jack. Plug 

the charging adapter cord into a standard electrical outlet (120V., 60Hz.) 
The green charging indicator should illuminate. If it does not, depress the 
On/Off switch one time. See charging instructions on page 6.

•

Use only with the battery pack supplied with the unit. 

•

Do not attempt to remove the battery pack from the unit to charge it.

•

Never attempt to throw the battery pack or unit into a fire or incinerate it.

•

Do not attempt to remove or damage the battery casing.

•

Battery must be recycled or disposed of properly at the end of it's service life.

Your cordless sweeper may be stored by using the slot on the back of the upper 

handle and hanging it from a screw secured to a wall or other vertical surface. 

Use a #6 flat or pan head screw with the appropriate hardware for the surface 

that the sweeper will be mounted on, (i.e. drywall). Allow the screw head to 

extend a approximately 3/16" from the mounting surface. Always empty your 

sweeper before hanging up for storage.

NOTE: If, when you place the sweeper to recharge and the charging 

indicator light does NOT illuminate, then press the On/Off button 

once to turn the sweeper off. The charging indicator light should 

now light up.

Peak performance may only be realized after the unit has been 

charged and discharged two (2) or three (3) times.

To maintain peak performance of your cordless 

sweeper, it is recommended that the unit be fully 

discharged, then completely re-charged at least 

once a month.