AIS Router AI2524 Manuale Utente
Chapter 16: Basic Configuration
August 1997
Page 16-1
2524UM
Chapter 16: Basic Configuration
Connecting to the
Network
Network
Connecting to an Ethernet Network
The AI2524 can be connected to an Ethernet network by:
z
Using a straight-through 10BaseT cable to connect the 10BaseT
port to a 10BaseT hub.
port to a 10BaseT hub.
z
Using a crossover 10BaseT cable to connect the 10BaseT port to
a PC network interface card.
a PC network interface card.
Connecting to a WAN
z
If you have a 4-wire 56K/64K DSU/CSU module, use a straight-
through RJ-48S-to-RJ48S cable to connect the RJ-48S port to an
RJ48S jack.
through RJ-48S-to-RJ48S cable to connect the RJ-48S port to an
RJ48S jack.
z
If you have a FT1/T1 DSU/CSU module, use a straight-through
RJ-48C-to-RJ48C cable to connect the RJ-48C port to an RJ48C
jack.
RJ-48C-to-RJ48C cable to connect the RJ-48C port to an RJ48C
jack.
z
If you have a synchronous serial module, use a transition cable to
connect the synchronous serial port to a modem or DSU/CSU.
connect the synchronous serial port to a modem or DSU/CSU.
Configuring
This chapter describes how to configure the AI2524 router and de-
scribes the following:
scribes the following:
z
Booting the Router for the First Time
z
Configuring the Router
z
Specifying the Boot Method
z
Checking the Configuration Settings
This chapter provides just enough information to get the router up and
running. Review the previous detailed configuration chapters for more
information
running. Review the previous detailed configuration chapters for more
information