Acnodes EPSON PERFECTION 1200S Manuale Utente

14

Install the SCSI Software

Once the SCSI interface card is installed in a PCI slot, your computer must locate and 

install the SCSI card’s software drivers. The scanner and the scanning software will 

not work if the SCSI card’s software drivers are not installed immediately after 

installing the card. You can disregard this section if your computer already has a SCSI 

port.
Windows 95/98, Windows NT 4.0, and Macintosh operating systems each have a 

different driver installation procedure, so follow the instructions below for your 

operating system. The scanner software comes on two CD-ROMs: one for Windows 

and one for the Macintosh. Make sure you have the correct CD-ROM for your 

operating system.

If You’re Running Windows 95 or Windows 98 . . .

Depending on how your computer system was originally set up, you may be asked to 

insert your Windows operating system CD-ROM during the SCSI software 

installation process. Please have your Windows CD-ROM handy in case it is needed.
Follow these steps to install the SCSI driver:
1. Turn off your scanner, then turn on your computer. During the Windows 

start-up sequence, a screen appears saying that your system has detected new 

hardware.

2. Click 

Next

. You see the screen to the right.

3. Make sure 

Search for the best driver for 

your device

 is selected. Insert the Windows 

EPSON Perfection 1200 CD-ROM in your 

drive, then click 

Next

.