Acclaim Lighting ACL7500U1 Manuale Utente

Pagina di 4
CONTENTS
GETTING STARTED ......................................................................................................................................... 2
CARING FOR YOUR BUILT-IN BATTERIES .......................................................................................................... 3
ACCLAIM LECTERN BASIC SYSTEM OPERATION ............................................................................................  4/5
OPERATING THE BUILT-IN UHF WIRELESS RECEIVER ......................................................................................... 6
ACCLAIM ACCESSORIES .................................................................................................................................. 6
OPERATING THE WIRELESS MICROPHONE / TRANSMITTER ............................................................................... 7
HAVING TROUBLE W/ YOUR SOUND SYSTEM? ................................................................................................ 8
ACCLAIM SOUND SYSTEM TECHNICAL SPECIFICATIONS .................................................................................... 8
HAVING TROUBLE W/ YOUR SOUND SYSTEM?
CONDITION 
POSSIBLE SOLUTION
No Sound 
(power LED off)
• turn POWER switch ON
• charge battery or plug in AC cord
Charge Indicator LED off
• leave plugged in for 48 hours to repair battery
No Sound 
(power LED on)
• check for output from source
• set Internal Speaker switch to ON
• make sure all cables are completely plugged in
• turn up volume control of input used
• remove plug from speaker output if not using external speaker output
Shortened Battery Life
• charge battery fully; if battery life continues to deteriorate, contact
Anchor Audio customer service: (888) 444-6077
Distorted Sound
• lower system volume control
Excessive Hum or Noise
• use shielded cables
• use balanced microphone
HAVING TROUBLE W/ YOUR WIRELESS SYSTEM? (WIRELESS MODELS ONLY)
CONDITION 
POSSIBLE SOLUTION
No Sound 
(RX Indicator: ON)
• set MUTE switch to on
(handheld mic only)
• turn up WIRELESS volume control
• make sure mic is plugged into body pack transmitter
No Sound 
(RX Indicator: OFF)
• push mic power button
• turn Acclaim POWER switch on
• make sure transmitter power switch is on
• set receiver and transmitter to same channel
• replace battery in transmitter
Anchor Audio, Inc.
Portable  Sound  Systems    •    Torrance,  California
100-0163-000/C - 4/09
OWNER’S MANUAL
ACCLAIM
pORTABLE LECTERN SOUND SYSTEM
ACCLAIM TECHNICAL SpECIFICATIONS
Rated Power Output
22 watts
Max SPL @ Rated Power
114 dB @ 1 meter
Frequency Response
60 Hz – 15 kHz ± 3 dB
AC Power Requirements
90 – 264 VAC, 50/60 Hz, 50 W max
Dimensions
Base (HWD)
14 x 22.5 x 13.5”/ 35.6 x 57 x 34.3
cm
Table Top
22.5 x 19” / 57 x 48 cm
Weight
30 pounds / 13.6 Kg
Inputs
Lectern Mic
Lo-Z, balanced, phantom power, XLR
Auxiliary Mic
Lo-Z, balanced, phantom power, XLR
Line
Hi-Z, unbalanced, 1/4” phone
Sensitivity For Rated Output
Lo-Z Microphone
-52 dBV (2.5 mVrms)
Hi-Z Microphone
-43 dBV (7.5 mVrms)
Auxiliary (line)
-14 dBV (200 mVrms)
Outputs
Line (post fader)
Lo-Z (<1k ohm), buffered, 1/4” phone
Microphone
Lo-Z, balanced, XLR
Speaker
switched – 8ohm, 1/4” phone
unswitched – 4ohm, 1/4” phone
ACL-BASE
Dimensions (HWD)
30.5 x 21.5 x 18.5”/ 77.5 x 54.6 x 47
cm
Weight
38 pounds / 17.2 Kg
(Specifications subject to change without notice)
ANCHOR AUDIO CUSTOMER SERVICE
888/444-6077       310/784-2300
For Setup & Operation Videos Go To:
 www.anchoraudio.com