Dot Hill Systems II 200 FC Manuale Utente
G-1
APPE NDIX
G
Configuring a Linux Server
This appendix provides access information and LUN setup information needed when
you connect a FC, SATA, or SATA SE array to a server running the Linux operating
system. For a list of supported adapters, refer to the SANnet II 200 FC, SATA, and
SATA SE Array Release Notes.
you connect a FC, SATA, or SATA SE array to a server running the Linux operating
system. For a list of supported adapters, refer to the SANnet II 200 FC, SATA, and
SATA SE Array Release Notes.
This information supplements the configuration steps presented in this manual and
covers the following topics:
covers the following topics:
■
■
■
■
■
■
■
■
■
G.1
Setting Up the Serial Port Connection
The RAID controller can be configured by means of a host system running a VT100
terminal emulation program or running a terminal emulation program such as
Minicom.
terminal emulation program or running a terminal emulation program such as
Minicom.
Note –
You can also monitor and configure a RAID array over an IP network with the
SANscape program after you assign an IP address to the array. For details, see “Setting
Up Out-of-Band Management Over Ethernet” on page 4-28 and refer to the SANscape
User’s Guide.
Up Out-of-Band Management Over Ethernet” on page 4-28 and refer to the SANscape
User’s Guide.
To access the controller firmware through the serial port, perform the following steps: