Dot Hill Systems II 200 FC Manuale Utente
I-4
SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005
I.3
Attaching the Disk Array
The simplest way to configure a disk array is to use System Administration Manager
(SAM), HP-UX’s system administration tool. If SAM is not installed on your system,
or if you prefer to use the command-line interface, the following procedures guide you
through the task. For more information, consult the HP document, Configuring HP-UX
for Peripherals:
(SAM), HP-UX’s system administration tool. If SAM is not installed on your system,
or if you prefer to use the command-line interface, the following procedures guide you
through the task. For more information, consult the HP document, Configuring HP-UX
for Peripherals:
1. Use the ioscan command to determine what addresses are available on the HBA to
which you will be attaching the array.
2. Access the firmware application on the array and set the SCSI IDs of the host channels
you will be using.
3. Map the partitions containing storage that you want to use to the appropriate host
channels.
Partitions must be assigned to LUNs in sequential order, beginning at LUN 0.
Partitions must be assigned to LUNs in sequential order, beginning at LUN 0.
4. Halt the operating system using the shutdown command.
5. Turn off all power to peripheral devices and then to the server.
6. Attach one or more host channels of the FC or SATA array to the SCSI interface cards
in the host using the supplied SCSI cables.
7. Turn on the power to the FC or SATA array and all other peripheral devices. After they
are initialized, power on the server and boot HP-UX. During the boot process, the
operating system recognizes the new disk devices and builds device files for them.
operating system recognizes the new disk devices and builds device files for them.
8. Verify that you can see the new storage resources by running the ioscan command.
You are now ready to use the storage.
Note –
If you create and map new partitions to the array, you can have them
recognized by the operating system without rebooting. Run the ioscan and the insf
commands to discover the resources and to create their device files.
commands to discover the resources and to create their device files.
I.4
Logical Volume Manager
The Logical Volume Manager (LVM) is a disk management system provided by HP in
all versions of HP-UX 11. The LVM allows you to manage storage as logical volumes.
This section describes some concepts used by the LVM and explains how to create
logical volumes on your SANnet II 200 Fibre Channel Array. For more detailed
information about the LVM, consult lvm(7) and the HP publication Managing Systems
and Workgroups: Guide for HP-UX System Administration (HP part number B2355-
90742).
all versions of HP-UX 11. The LVM allows you to manage storage as logical volumes.
This section describes some concepts used by the LVM and explains how to create
logical volumes on your SANnet II 200 Fibre Channel Array. For more detailed
information about the LVM, consult lvm(7) and the HP publication Managing Systems
and Workgroups: Guide for HP-UX System Administration (HP part number B2355-
90742).