Dot Hill Systems II 200 FC Manuale Utente
Chapter 4 Connecting Your Array
4-21
Figure 4-15 Host Channels on a Dual-Controller SANnet II 200 SATA Array
The following figure shows the host channels for a SANnet II 200 SATA SE array.
Figure 4-16 Host Channels on a Dual-Controller SATA SE Array
4.8.3
Default SFP Placement
Default configurations do not include an SFP connector in every SFP port. You might
want to add or rearrange SFPs, depending on the configuration mode (loop or point-to-
point), the number of planned host connections, the necessary number of redundant
connections to hosts, and the number of expansion units needed.
want to add or rearrange SFPs, depending on the configuration mode (loop or point-to-
point), the number of planned host connections, the necessary number of redundant
connections to hosts, and the number of expansion units needed.
The supported SFP is a single-port, optical SFP transceiver for multimode (short wave)
or single-mode (long wave) use. It is compatible with the Small Form Factor Pluggable
Multi-Sourcing Agreement (MSA, Sep. 2000), and 1x and 2x Fiber Channel. The
optical connector used is the low-profile LC connector.
or single-mode (long wave) use. It is compatible with the Small Form Factor Pluggable
Multi-Sourcing Agreement (MSA, Sep. 2000), and 1x and 2x Fiber Channel. The
optical connector used is the low-profile LC connector.
SFPs are field-replaceable units (FRUs) and can be ordered from Dot Hill. These SFPs
have been selected and tested to provide the necessary reliability and performance.
SFPs from other vendors are not supported.
have been selected and tested to provide the necessary reliability and performance.
SFPs from other vendors are not supported.
Host channel 0
Host channel 1
Host channel 4
Host channel 5
An upper port and a lower port are on each host channel.
Host channel 0
Host channel 1
Host channel 4
Host channel 5
An upper port and a lower port are on each host channel.