Digidesign Control 24 Manuale Utente

Ethernet Connections

When Control|24 is the only Ethernet device 
connected to your system, it can be connected 
directly to the built-in Ethernet port on all qual-
ified Mac computers, using the included “cross-
over” Ethernet cable. 

If you have one or more Ethernet devices al-
ready, or if a Control|24-equipped system is to 
be connected to an Ethernet network (for e-
mail, file transferring or other typical uses), you 
must use a standard RJ45 Ethernet cable to con-
nect Control|24 to a powered Ethernet hub or 
Ethernet card. 

Control|24 can be connected to 10-, 100-, or 
1000baseT hubs. 100baseT and 1000baseT hubs 
must be “switching hubs” however, meaning 
they can recognize and adapt their operation to 
the 10baseT (the operating speed of Control|24 
communication). 

For a more details on Ethernet connections, see 
“About Control|24 and Ethernet Performance” 
on page 9.

Audio Cables for Control|24 
Monitoring

The back panel of Control|24 provides numer-
ous analog inputs and outputs, such as mic 
preamp inputs, submixer inputs, land line out-
puts. 

Standard 25-pin D-Sub wiring harnesses are re-
quired to access the mic preamps, line submixer, 
and other analog inputs and outputs available 
with Control|24.

DigiSnakes for Control|24

DigiSnake cables are available from Digidesign 
in kits for common Control|24 installations, or 
individually for unique setups.

For more information on input and output op-
tions available in Control|24, see Chapter 3, 
“Audio Connections.”