Digidesign Control 24 Manuale Utente

Channel Automation Controls

The AUTO switch is located above the SELECT 
switch. Next to this are five Automation mode 
LED indicators. 

The AUTO switch is used to set channel automa-
tion mode, and to punch out of automation re-
cording on a channel during an automation 
record pass (placing the channel in Read mode). 

The LEDs next to the AUTO switch indicate the 
various automation modes and their present sta-
tus. The auto modes are indicated by the labels 
as follows:

WR LED (red) 

indicates Write mode. 

TC LED (red) 

indicates Touch mode.

LT LED (red) 

indicates Latch mode.

TM LED (yellow) 

indicates Trim mode is enabled 

(for Read, Write, Touch, or Latch). 

RD LED (green) 

indicates Read mode.

All LEDs Off 

indicates that automation is off for 

the channel.

The channel AUTO switch can also be used in 
combination with the master AUTOMATION 
MODE and ENABLE switches.

Master Automation MODE and 
ENABLE Switches

To the left of the channel faders is the AUTO-
MATION section that includes the six master 
AUTOMATION MODE switches and the six AU-
TOMATION ENABLE switches.

Instructions for setting, recording and editing 
automation can be found in Chapter 14, “Auto-
mation.”