Digicom COMSPHERE 3911 Manuale Utente
COMSPHERE 3900 Series Modems
13-4
September 1998
3910-A2-GN32-40
If operation over the secondary channel is desired, press any function key to select the secondary
channel. Secondary channel only appears if using V.32terbo, V.32bis, V.32 or TMp
modulation. If operation over the primary channel is desired, press the
channel. Secondary channel only appears if using V.32terbo, V.32bis, V.32 or TMp
modulation. If operation over the primary channel is desired, press the
key until primary
displays and press any function key. Primary channel operation is not available when
initiating a Remote function from a TMp tributary modem.
initiating a Remote function from a TMp tributary modem.
F1
Online:14.4
Control
Control
ExitRem
F2
F3
If the remote modem accepts the password and the entry is successful, the Top-Level menu of
the remote modem appears on the local modem’s LCD. An appears in the upper right-hand
corner indicating that what is displayed on your LCD is actually the Top-Level menu of the
remote 391x Series modem. If the message Remote FP Busy appears, the remote modem’s front
panel is already in Remote mode.
the remote modem appears on the local modem’s LCD. An appears in the upper right-hand
corner indicating that what is displayed on your LCD is actually the Top-Level menu of the
remote 391x Series modem. If the message Remote FP Busy appears, the remote modem’s front
panel is already in Remote mode.
Status
“Status”
Configure
PList
Control
Test
SubHS
Call_Setup
ExitRe
m
The Top-Level menu of the remote 391x Series modem is similar to the local 391x Series
modem with the following exceptions:
modem with the following exceptions:
•
The Talk/Data and Security branches do not appear.
•
Change Directory is the only function available under the Call Setup branch.
•
Local Analog Loop and Remote Digital Loop do not appear under the Test branch when
using the secondary channel. When using the primary channel, the Test branch does not
appear.
using the secondary channel. When using the primary channel, the Test branch does not
appear.
•
Poll List Display is the only function available under the PList branch.
•
Exit Remote replaces Remote on the local modem’s LCD.
To return to local modem operation, select ExitRem. Any changes made to configuration options
in the remote modem are saved.
in the remote modem are saved.
The following conditions can cause Remote branch access to fail:
•
The local modem is not able to communicate with the remote modem because of a poor
dial network or leased-line connection, or the remote modem is not a 3900 Series modem.
If this is the case, the status message No Response appears on the LCD.
dial network or leased-line connection, or the remote modem is not a 3900 Series modem.
If this is the case, the status message No Response appears on the LCD.
•
If a connection is established but the remote modem’s Access from Remote configuration
option is disabled, then the status message Access Disabled appears on the LCD.
option is disabled, then the status message Access Disabled appears on the LCD.