DeLonghi DRAGON 3 Manuale Istruttivo
5
Programming the Electronic Timer
The timer allows you to set two programs in a 24h period.
To program the timer:
Press the “Timer function A“ (2) ; this accesses the program and the following is displayed:
-
To program the timer:
Press the “Timer function A“ (2) ; this accesses the program and the following is displayed:
-
The flashing message “--:--“;
-
The message “ON” at the bottom left (ON time setting);
- The symbol “A” at the right indicating that the first program controlling is
being set;
To setting the starting time press “hour button” (9) to set the hour and “min
button” (8) to set the minutes, then confirm the ON time by pressing the
“Timer function A” (2) button again. The words “OFF” and “00:00” appear
on the display.
“Timer function A” (2) button again. The words “OFF” and “00:00” appear
on the display.
- Set the time you want the appliance to go off using the “hour button” (9)
and “min button” (8), then confirm the off time by pressing the “Timer
Function A” (2) button again (fig.5).
Function A” (2) button again (fig.5).
- At this point, the word “AUTO” appears at the top of the display and the
“TIMER ON” (3) indicator light comes on to indicate that the appliance is
ready to operate at the programmed time maintaining the preset comfort
temperature.
ready to operate at the programmed time maintaining the preset comfort
temperature.
- To set the program B press “Timer function B” (4) button and follow the
same procedure as described for the program A.
- Use the “ +” (6) or “ -” (5) buttons to set the desired comfort tempera-
ture, as described above.
- When set in this way the heater will automatically switch on at the set time
for the designated time period and automatically maintain the preset com-
fort temperature.
fort temperature.
To cancel a preset programme, press the timer button A or B once and then press
the hour button until the display shows “--:--“ (fig.6).
the hour button until the display shows “--:--“ (fig.6).
Remote Control Operation
- When you press the the frost protection push button, the
radiator will set the temperature to 5°C and will switch on automatically only if the room tempera-
ture falls below 5°C, thereby preventing freezing, at minimum energy consumption.
The “Timer ON” light on the control panel will flash.
ture falls below 5°C, thereby preventing freezing, at minimum energy consumption.
The “Timer ON” light on the control panel will flash.
- Press the increase/decrease temperature button (+/-) to adjust the temperature from 5°C to 35°C.
- The “Off” button switches off the appliance.
- The “Off” button switches off the appliance.
Every time you press a button, the appliance will confirm the selection with a “beep” and the pilot
light on the remote control will illuminate.
light on the remote control will illuminate.
AUTO
1
2
3
4
5
6
7
8
9
10
fig. 5
fig. 6
OFF
+
-
Frost protection button
Increase temperature
button
button
Decrease temperature
button
button
Pilot light