Danby DWM5500W Manuale Utente

Pagina di 34
INSTRUCTIONS FOR USE  
Instructions for Use
 
5
 Important
Before putting the machine into use, don't 
forget to remove the transport brackets. 
Switching on a blocked machine may damage 
the machine. Our guarantee does not cover 
such damage.
 
• Before switching the machine on, check that 
the transport brackets have been removed.  
• Don't place the appliance in a room where the 
temperature may fall bellow 32°F, causing 
individual parts of the machine to freeze and 
become damaged (hose may crack). 
• 
The appliance should stand firmly and 
horizontally on a solid base (a machine 
standing on an uneven floor is very likely to 
vibrate during the spinning cycle). 
• Always consider the instructions for correct 
placing and installation of the machine to the 
mains and water supply. This will help you 
avoid accidents and protect your machine 
against damage. 
• The end of the outlet hose should not be 
immersed in the discharge water (the machine 
may pump the discharge water back). 
• During the washing cycle, the door of the 
machine cannot be opened. It can only be 
opened 2 minutes after washing is finished. 
• The glass door gets very hot during washing, 
so take care of children.  
• Use only washing powder and other agents 
specially designed for machine washing. 
We do not take any responsibility for damage 
caused by the improper use of bleaching or 
coloring agents (colored gasket and other 
plastic parts). 
• Lime dissolving agents contain acid, so only 
use those containing rust-protection agents. 
Always consider the manufacturer's 
instructions. When you have finished removing 
lime deposit, run a few rinse cycles to make 
sure that the acid is thoroughly rinsed. Even 
traces of acid can cause substantial damage to 
component parts. 
• Never use washing agents containing solvents 
- individual component parts may be damaged 
or toxic gases may be produced. There is also 
a risk of ignition or explosion. 
• When washing is finished, remember to close 
the tap. 
• Your washing machine can only be transported 
with transport brackets. It is usually enough to 
use only one of the rods, that is the upper one. 
It is much easier to insert the rod if you remove 
the top cover. Before doing anything, however, 
don't forget to disconnect the machine from the 
power supply. 
• Data plate with essential information on the 
appliance is fitted above the opening for 
laundry insertion under the door frame. 
(UKS) - Unbalance Control System 
This washing machine is equipped with the UKS 
- unbalanced control system. This means that the 
spinning starts smoothly, even in case of smaller 
wash loads or inadequate loads. 
In case of unfavorable distribution of laundry in 
the drum, this is sensed by the UKS system and 
the automatic re-distribution of the laundry 
follows immediately, then only spinning starts.  
In case the re-distribution of the laundry is not 
successful (only one large piece in the drum), the 
UKS system reduces the spinning speed (r.p.m.), 
to prevent damages to the washing machine.