HP AR157AW Manuale Utente

HP Remote Graphics Software (sold separately)

HP Remote Graphics Software (RGS) is a unique high performance network display technology, developed by HP, which uses a high
compression rate and high-speed encoding/decoding process to deliver a true desktop experience through a remote connection.

Following its success with the HP Blade Workstation Solution, HP RGS is now available for the HP bc2800 Blade PC as an
alternative to the Microsoft Remote Desktop Protocol.

HP RGS can ber purchased separately. For more information, please visit

www.hp.com/go/rgs

HP BladeSystem PC Blade Enclosure (sold separately)

Rack Capability

Includes the either the HP BladeSystem PC Blade Switch or the HP BladeSystem RJ-45 Patch Panel pre-
installed within the enclosure. Mounts in HP 10000 and 9000 series, HP System-E, as well as third-party
and Telco racks. Rack mounting hardware for HP and third-party racks ships standard with each blade
enclosure. Telco rack-mounting hardware is a separately available option kit.

Rack Airflow

Rack Airflow
Requirements

Requirements

The HP 10000 Series Racks provide enhanced airflow for maximum cooling, allowing these racks to be
fully loaded with blade PCs using the latest processors.

CAUTION:

CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:

Front and rear doors: If your 42U rack includes closing front and rear doors, you must allow
5,350 square cm (830 square inches) of hole evenly distributed from top to bottom to permit
adequate airflow (equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be
a minimum of 7 cm (2.75 inches).

CAUTION:

CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling
that can lead to thermal damage.
NOTE:

NOTE:

NOTE: Please consult the Setup & Installation Guide for the blade PC for additional details.

Enclosure Includes

Pre-installed HP BladeSystem PC Blade Switch or Pre-installed HP BladeSystem PC Blade RJ-45
Patch Panel
3U high rack-mountable chassis with 20 blade PC bays
Rack mounting hardware for HP, Compaq-branded, and third-party racks
Rear bay for HP BladeSytem PC Blade Switch or HP BladeSystem PC Blade RJ-45 Patch Panel for
network cable management
ProLiant Essentials Foundation Pack licenses for 20 blade PCs (see features following)
Four hot-plug fans
Dual hot-plug power supplies (600 watts each), power cords

QuickSpecs

HP BladeSystem bc2200 and bc2800 Blade PC

Options/Memory

DA - 13209 North America — Version 3 — July 23, 2009

Page 17